DIY Fleur De Lis Resin Pendant ~ Craft Klatch Jewelry

To stay up on the latest, be sure to 
You can click right HERE!  
Like my FACEBOOK page HERE!

I found these bezels in the clearance section of Hobby Lobby. I paid $1.79 for 8 pieces.  Score!  I found the fleur de lis for half off.  Double Score!

The links below are affiliate links.  I may receive a small commission, at no additional cost to you. 

You will need:
–  Pigment powder:
–  Fleur de lis:
–  Bezel:
–  Resin (use whatever resin brand you like):
Easy Cast:
Art Resin:
Clear Cast:
FX Poxy: ~ According to the manufacturer, this one is heat resistant to 500 degrees F.

Here is the video tutorial:

1.  I found a package of bezels in the clearance section.  ALWAYS CHECK THE CLEARANCE SECTION!  

The bezel I have happens to have a hole in it.  No big deal, I took some packing tape and put it on the back.  I made sure I rubbed it down really well, so the resin would not be able to seep out.

2.  Mix the resin according to the package directions.  I mixed 1/2 ounce and still had too much for the bezel.

3.  I split the resin into three cups and mixed a different pigment powder into each.  

4.  Using my stir stick, I dripped the different colored resins into the bezel.

5.  I used a toothpick and swirled them a little.

6.  I popped the bubbles with a lighter and allowed it to cure 12 hours.

7.  I mixed more resin and dropped the fleur de lis into it.  I then scooped it out and placed it into the bezel.  I did this because that way there would not be any air bubbles trapped behind the fleur de lis because it was already covered in resin.

8.  I then filled the rest of the bezel up with resin.  I used my lighter to pop any bubbles and then let it cure.

9.  I removed the tape from the back of the bezel.

That’s it!  Hope you like it!  Thanks for stopping by.  Remember:  Life’s too short not to shimmer, so grab your glue gun and your glitter!™  Stay safe!


1 thought on “DIY Fleur De Lis Resin Pendant ~ Craft Klatch Jewelry”

Leave a Comment