Valentine’s Day Arrow Resin Coaster | Another Coaster Friday | Craft Klatch

Learn how to make Valentine’s Day resin coasters in this easy resin craft tutorial!


Here is a quick video, so you can see exactly how I made it:

You will need:
The links below help support this channel,  as I may earn a small commission at no extra cost to you.

Coaster Mold:  https://amzn.to/2FcRd7J
Arrows:  I found them at Hobby Lobby
Ribbon:  I’m not sure where I found it, but you can substitute anything you like!
Resin (use whatever resin brand you like):
This is the resin I used for this project:
FX Poxy:  https://amzn.to/2AF3Pkk ~ According to the manufacturer, this one is heat resistant to 500 degrees F.

Directions:

1.  I gathered my items, which included these little acrylic arrows and some Happily Ever After ribbon that I had collecting dust in the craft room.

2.  I mixed one ounce of resin and poured most of it into the mold.

3.  I used my lighter to pop the bubbles.

4.  I cut my ribbon and put the pieces into the resin.  I started with the Happily Ever After face down, on a couple of pieces.

5.  I pressed each piece down with my stir stick.

6.  I then added the rest, with the Happily Ever After face up.

7.  I used my lighter to pop the bubbles.

8.  I added a little more resin, to top it off.

9.  I popped the bubbles again. 

10.  I used a little super glue to adhere the arrows and hearts.

11.  I mixed two ounces of resin, just to make sure the arrows and hearts will be fully covered.

12.  I popped the bubbles.  It has been VERY cold here and I had to come back several times.  I let everything sit for a minimum of 12 hours.

13.  I removed the coaster.

 ❤️Here it is!  Ready for love and Happily Ever After!❤️

Thanks for stopping by!  Remember:  Life’s too short not to shimmer, so grab your glue gun and your glitter!™  Stay safe!

Mona

Leave a Comment